Placement Guide - OVERSHOES VELOTOZE

The overshoes veloToze has an exclusive and patented design by the Californian firm veloToze® that eliminates the use of zippers and uses two snaps located at the bottom as a closure system.

This system ensures quick and easy donning and an optimal fit to the cycling shoes during pedaling.

On this page we provide you with some simple instructions to show you how easy it is to put them on.

Warning: the overshoes may tear if you do not follow these instructions and try to put it on with your shoes on.

Fitting instructions

  1. Put on the sock.
  2. Place the overshoes veloToze over the sock above the ankle.
  3. Make sure the fasteners are open.
  4. Put on the shoes and adjust them correctly.
  5. Adjust the overshoes at the ankle, heel and then the cleat and toe area.
  6. Snap the snaps at the bottom closed.

Important: no part of the overshoes veloToze should rest on the heel or toe heels, otherwise it could tear or break while walking.

<img src='https://cdn.shopify.com/s/files/1/0052/7876/1029/files/GOBIK-VELOTOZE-INSTRUCTIONS.jpg?v=1673448183' alt=''>

How to remove veloToze

  1. Carefully unfasten the snaps located at the bottom.
  2. Release the overshoes from the toe and cleat area and then from the heel.
  3. Place the overshoes above the ankle and remove the shoes.
  4. Once barefoot, gently remove the overshoes and store out of direct sunlight.

PROTips

  • To make it easier to put them on next time, add baby powder to the inside of the overshoes after use.
  • If you want to prevent water from entering the cleat area, remove the insoles from the shoes and place duct tape over the ventilation openings to seal the shoe.
  • To prevent water from entering through the upper, always place overshoes higher than socks and below bib tight or leg warmers.
  • Always avoid contact with sharp objects.