The boot cover veilToze boot cover has an exclusive and patented design by the Californian firm veloToze® that eliminates the use of zippers and uses two snaps located at the bottom as the closure system.
This system ensures quick and easy donning and an optimal fit to the cycling shoes during pedaling.
On this page we provide you with some simple instructions to show you how easy it is to put them on.
WarningWarning: the boot covers may tear if you do not follow these instructions and try to put it on with your shoes on.
Fitting instructions
- Put on the sock.
- Put on the veloToze boot cover over the sock above the ankle.
- Make sure the fasteners are open.
- Put on the shoes and adjust them correctly.
- Adjust the boot covers at the ankle, heel and then the cleat and toe area.
- Snap the snaps at the bottom closed.
ImportantNo part of the veloToze boot cover should be over the heel or toe heels, otherwise it could tear or break when walking.
How to remove veloToze
- Carefully unfasten the snaps at the bottom of the veil.
- Release the boot cover from the toe and cleat area and then from the heel.
- Place the boot cover over the ankle and remove the shoes.
- Once barefoot, gently remove the boot covers and store them out of direct sunlight.
Tips PRO
- To make it easier to put them on next time, add baby powder to the inside of the boot covers after use.
- If you want to prevent water from entering the cleat area, remove the insoles from the shoes and place duct tape over the ventilation openings to seal the shoe.
- To prevent water from entering the upper area, always place the boot covers higher than the socks and underneath the bib shorts or leggings.
- Always avoid contact with sharp objects.
